3D printing probe holder

FishieBusiness

Well-Known Member
BRS Member
I know that there are a few members with 3d printing capability.

Is there anyone making probe holders for Aquarium controllers?? Apex probes??
 
I am working on finishing up the first proto today. If I do not need to make any changes these will hit the site by Thursday and will be $14.99 shipped. It will be a 4 probe holder that has 1 opening specifically for the thicker diameter apex temp probe and then 3 other slots that fit standard probe sizes. Of course if anyone needs any custom sizing I can do that as well.
 
The problem is not the making or the printing of the holder. The problem is getting magnets in a form that will not be an issue in the water.

I really wish companies would seal them inside a potted epoxy volume for ZERO water contact ...
 
As I'm sure it has mentioned before but plastic-coated magnets seem to be the best long-term bet. I have also been getting them only in white so that any degradation is more easily visible (than black plastic for example) as the rust stains, if the coating is compromised, are easily visible.
 
Upcoming Events

April 21, 2024
Paul B
Club Meeting

Back
Top