reefer125g
Non-member
Custom 80 gallon water storage tank .
Auto water change system
- Thread starter reefer125g
- Start date
Custom 80 gallon water storage tank .
OP
OP
reefer125g
Non-member
Fits perfectly under frag tank .
OP
OP
reefer125g
Non-member
Optical sensors set for high point of water . And low point with 20 gallons remaining in tank . Incase I cant get to mixing salt right away. Also backup safety float shutoff.
GraniteReefer
Non-member
I have some John guest bulkhead style fittings if you need them for those tubes that go through, not sure how you did it!
rock-n-reef
Well-Known Member
@reefer125g that is a nice setup! Can I ask who built the storage tank? is that made of HDPE?
OP
OP
reefer125g
Non-member
Polypropylene. A buddy of mine made it with me in my garage you can by the plastic in 4x8 sheets and it is all plastic welded.
OP
OP
reefer125g
Non-member
John guest fitting drilled and taped the tank so that thread right in . Thank you for the offer.
rock-n-reef
Well-Known Member
thank you!
OP
OP
reefer125g
Non-member
DOS FMM and Eb832 all installed. Still need to clean up wires and hoses. Will have to drill some holes to hide the wires behind the board and paint it gray !
OP
OP
reefer125g
Non-member
OP
OP
reefer125g
Non-member
This new to added also. Thanks to Jay from Jay's Aquatics .
FREAKINRICAN69
Well-Known Member
Nice looks awesome chief.
OP
OP
reefer125g
Non-member
Added a little bling to the tank . Looking for reef related stickers!
OP
OP
reefer125g
Non-member
Got corals ? Lol
Reefer_Rob_1987
Non-member
Really cool set up reefer125g! Do you mind if I ask what the ball valve is for on the line coming out of the DOS? Thanks -Rob
OP
OP
reefer125g
Non-member
That ball valve is to shut off the wastewater line on out put side . It goes over the ceiling and is a 60 ft run .So if I need to work on the line or the DOS . Residual water in the line does not back flow.
Reefer_Rob_1987
Non-member
Thanks for the response that is clever!
