Apex ATO program

[wcj_ink]

so I noticed that my ato has been going over the top sensor and that the float valve has been doing its job and sending me alarms. I want to make it so the water level never reaches the HI sensor so will this programming work or does anyone have a better solution?

 

[jsak1976]

It will work but it will cycle the ATO a lot. You have code in there that is not necessary also. And yes there is a better way to set it up. I would be more concerned about why the water level is going above top sensor and shutting off with the float valve.

 

[wcj_ink]

I figured that code isn’t necessary but i put it in there anyways but I did just figure out what happened. The water level in the overflow has risen up today and the extra water was going down the emergency drain which is draining into the return side of the sump making it look like my ato wasnt shutting off. I adjusted the valve on the main drain and its all back to normal now.