I have little patience.
While emptying my skimmer today, I noticed a big ol' O-ring in the bottom of the sink. It's the same diameter as the riser tube, so obviously it is the gasket between the twist-off neck and the main riser tube.
I see where the O-ring fits onto the riser tube.
Now the question: how do I replace the O-ring in the groove?
Every time I try pushing it back into place, it just falls back out when I move on down the line.
Did I mention I have very little patience for machines and gadgets?
Do I need to hot glue this gasket into place or something?
Thanks,
Moe
While emptying my skimmer today, I noticed a big ol' O-ring in the bottom of the sink. It's the same diameter as the riser tube, so obviously it is the gasket between the twist-off neck and the main riser tube.
I see where the O-ring fits onto the riser tube.
Now the question: how do I replace the O-ring in the groove?
Every time I try pushing it back into place, it just falls back out when I move on down the line.
Did I mention I have very little patience for machines and gadgets?
Do I need to hot glue this gasket into place or something?
Thanks,
Moe