-
******* To read about the changes to the marketplace click here
Corner
- Thread starter hanse_2020
- Start date
Looks like it's just the plastic trim. You could probably epoxy it but I don't really know.
I would second the epoxy concept. It's going to be much stronger than plastic. Just make sure all the surfaces are clean.
hanse_2020
Non-member
Is there a video I never use epoxy
hanse_2020
Non-member
Is there a video I never use epoxy
If it was me I would look into using something like a JB weld. I would read the package, clean up the area to be patched. Then stand the tank as it would normally be on a flat surface with a piece of wax paper (so you don't adhere the tank to the stand) underneath that corner and then press the putty into the repair area and smooth out the exterior so it matches the plastic. Let it dry then try to match it with a little paint. I would think that would give that area at least as much strength as the plastic would
Google and YouTube is your friend for everything and anything that you don't know how to do. About 5-6 years ago, a friend asked me to help him build a deck on his house. It's been close top 20 years since I did before that, watched a YT video on how to cut the stringers for the stairs and all went as it should have. Good luck
