I picked up a used JBJ ATO. I set it up in my bio cube. Sensor 1 in the back of the tank, sensor 2 in the water refill. And set it on mode A. The sensors I cannot get to work consistently. The water level will drop and in theory the sensor kicks the pump on.
When I came home, the red light was on, and my chamber at minimum level from evaporation.
I tried testing to see if the issue was the sensor so I traded the ports. Same deal. The red light would click on, but the pump doesn't. I had to click either sensor on and off a couple times to get the pump to kick in (brand new toms aqualifter). Do you think it's the actual unit or the sensors themselves? What are the chances both are inconsistent. Anyone have this issue with JBJ's? And how'd you fix it. The warranty is out since I bought it used.
Sent from my iPhone using Tapatalk
When I came home, the red light was on, and my chamber at minimum level from evaporation.
I tried testing to see if the issue was the sensor so I traded the ports. Same deal. The red light would click on, but the pump doesn't. I had to click either sensor on and off a couple times to get the pump to kick in (brand new toms aqualifter). Do you think it's the actual unit or the sensors themselves? What are the chances both are inconsistent. Anyone have this issue with JBJ's? And how'd you fix it. The warranty is out since I bought it used.
Sent from my iPhone using Tapatalk