which ink bird/heater

[absolutecarrot]

So recently my heater has been malfunctioning and putting the temp everywhere. Last night it went down to 70 degrees. I took all day slowly bring it up. But the heater still has a not been working right and is sometimes at 81 and other times at 70. My question is which ink bird heater controller do I buy because I see that there are two options. Im also thinking about getting a new heater, does anyone use ehiem jagers, Thanks

option one

option two

 

[absolutecarrot]

The cobalt heater was flickering so I took it out and put in an aqueon one which has been very realible.

 

[afboundguy]

I just bought the wifi version like it so far. Super easy to set up...

 

[absolutecarrot]

I just bought the wifi version like it so far. Super easy to set up...

Thanks I’m thinking of getting that one

 

[afboundguy]

I felt the extra money was worth it for the ability to track and control temp from my phone... Tank temp has been spot on since right at 76.5 ever since I installed it...

 

[absolutecarrot]

Is this good, does the t1 mean the high temperature and t2 mean the low temp

 

[afboundguy]

I would swap it put so high temp is T2 and low is T1 and tighten it to within 1 degree swing for better stability...

 

[absolutecarrot]

I would swap it put so high temp is T2 and low is T1 and tighten it to within 1 degree swing for better stability...

Thanks

 

[afboundguy]

If you want a 3D printed holder for the inkbird so you don't have to just mount it with a single screw shoot @Frag Freaks a pm they're making me one for my inkbird and for my Jebao controller

 

[absolutecarrot]

If you want a 3D printed holder for the inkbird so you don't have to just mount it with a single screw shoot @Frag Freaks a pm they're making me one for my inkbird and for my Jebao controller

Thanks I’ll check it out

 

[Frag Freaks]

Thanks I’ll check it out

Here is the model of the holder I will be printing.