How can I get the Conductivity (Salinity) to show on the display module, it shows all other data but no conductivity?
Jim
Jim
I've never used this but wouldn't it be in the display settings (from the computer interface, not fusion) enable 2nd probe then select it from the pull down menu.
Again not sure just a thought while sitting on the couch
Ok do you know what the ip for your apex is? It will be in the display if you go to system-net setup-ip address..... you will see a number that should look so ething like. 192.168.1.4....likely only the last number will be different.
Next open a Web browser on any computer connected to the SAME network as the apex. And type in that number with :8080 at the end (ie 192.168.1.4:8080). It may prompt you for a password if so the default is
User...admin
Pass...admin
From there you are in the apex dashboard. There many things you can do to program from here you cannot from fusion.
How'd you make out?