DIY frag rack for Eurobraced tanks

[Greg Hiller]

I used a single strip of acrylic and bent it in several places with a propane torch. The fold slips right onto the Eurobrace of my tank. I bored a few holes in it with my dremel tool, and tie wrapped it to a piece of egg crate. Since it leaned a bit in my tank I put some silicone tubing (remember that stuff I brought into a meeting last year?) split lengthwise to keep frags from falling off. Took about 20 minutes total.

 

[stevenp]

Nice tangs!

And nice frag rack too

BTW, I was fortunate enough to get some of that silicone tubing from you. Nice stuff!

 

[MAReefer1]

nice job greg!

 

[JonNewland]

You wouldn't be putting this thing in that good looking tank up there? Are you?

 

[Greg Hiller]

Yup, but just short term on occasion.