I am going to DIY a new mega sump for my tank.
I am going to take the basic design from
http://www.melevsreef.com/dfwmas/plin/115g_sump.html
but I want to make the propogation tank much bigger as it will be a
"display" tank built in the wall for the finished basement.
What I can't find is how to figure out the number of teeth I need for flow rate flow from one chamber to another.
I will be using my amp 4700 pump and everything (about 3000GPH) will go through the sump.
Thanks Corwyn
I am going to take the basic design from
http://www.melevsreef.com/dfwmas/plin/115g_sump.html
but I want to make the propogation tank much bigger as it will be a
"display" tank built in the wall for the finished basement.
What I can't find is how to figure out the number of teeth I need for flow rate flow from one chamber to another.
I will be using my amp 4700 pump and everything (about 3000GPH) will go through the sump.
Thanks Corwyn
