phg1960
Well-Known Member
I just setup a new tank and am trying to reuse an older PacSun Hyperion. Everything works fine, but for some reason, it won't run a custom scenario. I loaded a new file to the light and read it back without problems.
In the manual, there is a line that states to run custom scenarios "Linear PAR simulation option switched on"
The only physical switch is for power. This is probably a software switch and I do see a section in the config file for "switches" but have no idea what to input.
Does anyone know how to set or verify this setting?
In the manual, there is a line that states to run custom scenarios "Linear PAR simulation option switched on"
The only physical switch is for power. This is probably a software switch and I do see a section in the config file for "switches" but have no idea what to input.
Does anyone know how to set or verify this setting?
Last edited:
