Has anyone ever sectioned off a tank with semi permanent divididers while up and running? I really do not want to have to take it offline vinegar clean the coralline and glue in acrylic as down the road I may want to open it back up so would like to have removable divoders and why not
Be able to install them while the tank is full if I engineer it correctly!!
I have a 40 long bb frag tank that will be converting into 4 sections. I read an article on pressure fitting baffles using Epdm marine safe weather stripping and am considering it. Anyone use it???
Or what about cutting my acrylic dividers and having them just a tad smaller than the width and holding them in place with magnets???
Thoughts suggestions???
Which magnets would i get as magfloats would be expensive...
Also with a skill saw and drill any ideas how to make teeth?
Should I use egg crate for any part Of this????
Gutter guard??? Is that leach stuff bad??
Thanks for help
Be able to install them while the tank is full if I engineer it correctly!!
I have a 40 long bb frag tank that will be converting into 4 sections. I read an article on pressure fitting baffles using Epdm marine safe weather stripping and am considering it. Anyone use it???
Or what about cutting my acrylic dividers and having them just a tad smaller than the width and holding them in place with magnets???
Thoughts suggestions???
Which magnets would i get as magfloats would be expensive...
Also with a skill saw and drill any ideas how to make teeth?
Should I use egg crate for any part Of this????
Gutter guard??? Is that leach stuff bad??
Thanks for help